Skip to main content


         This documentation site is for previous versions. Visit our new documentation site for current releases.      
 

Enabling Genesys SDK tracing

Updated on September 11, 2020

To assist with debugging, enable tracing on Genesys' SDK.

  1. In the header of Dev Studio, click ConfigureChannel ServicesPega CallAdministration & Configuration.

  2. Open the CTI Link to which you want to enable tracing.

  3. On the Advanced tab configure the following parameters:

    Genesys SDK Trace LevelSet this to Off to turn off tracing. You can set the trace level to Fatal, Error, Warn, Info, Debug, Trace or All in order to receive increasing levels of trace messages.
    Log FilenameSpecify a name for the log file. The file will be created in the same folder as the Pega Platform logs.
    Max log file sizeSpecify a limit to the size of the log file, in megabytes.
Result: Any changes made takes effect the next time the CTI link starts.

Have a question? Get answers now.

Visit the Support Center to ask questions, engage in discussions, share ideas, and help others.

Did you find this content helpful?

Want to help us improve this content?

We'd prefer it if you saw us at our best.

Pega.com is not optimized for Internet Explorer. For the optimal experience, please use:

Close Deprecation Notice
Contact us