Skip to main content


         This documentation site is for previous versions. Visit our new documentation site for current releases.      
 

Step 3: Mapping the application data

Updated on September 18, 2020

The application data types provide a default set of properties for your use. You can add or remove properties from these data types depending on your requirements. You can also add new data types.

  1. In the explorer panel, click Data.
  2. Click the desired data type.
  3. On the Datamodel tab, determine the properties to add, remove, or leave unchanged.
  4. Repeat these steps for all other desired data types.
  • Previous topic Pre-configured FHIR® REST Connector data pages
  • Next topic Step 4: Defining common codes management requirements

Have a question? Get answers now.

Visit the Support Center to ask questions, engage in discussions, share ideas, and help others.

Did you find this content helpful?

Want to help us improve this content?

We'd prefer it if you saw us at our best.

Pega.com is not optimized for Internet Explorer. For the optimal experience, please use:

Close Deprecation Notice
Contact us