Skip to main content


         This documentation site is for previous versions. Visit our new documentation site for current releases.      
 

Configuring a part validation

Updated on May 20, 2022

Use the PartsValidationflow rule to loop through the parts list in the claim unit and apply the validation on each line to check for any exceptions.

The outcome of this flow is held in the ClaimException stop-level page, which is updated with the exceptions that are related to the parts data.

The PegaMfg-Data-ClaimCmp-Parts.PartsValidation decision table defines the exception codes that are related to the parts data. This table handles validations based on ClaimType and InvoiceNumber properties.

All the rows are evaluated to handle multiple exceptions on a single line.

  • In the navigation panel of Dev Studio, click Records.
  • Click Decision > Decision Table.
  • Click the filter for Purpose and search for PartsValidation.
  • Click the corresponding rule to open it.
  • Configure as needed and save the rule into your implementation layer. For additional information about locked and unlocked rulesets, see Copying a rule or data instance.
  • Click Save.

Have a question? Get answers now.

Visit the Support Center to ask questions, engage in discussions, share ideas, and help others.

Did you find this content helpful?

Want to help us improve this content?

We'd prefer it if you saw us at our best.

Pega.com is not optimized for Internet Explorer. For the optimal experience, please use:

Close Deprecation Notice
Contact us