Connect-MQ method

Use the Connect-MQ method to invoke a connector to an external system that uses IBM WebSphere MQ messaging services.

Parameters

This method operates on a named clipboard page that is the source and destination of data mappings. Make sure the Step Page column that calls this method contains the non-blank name of such a page.

This method has two parameters:

Parameter Description
ServiceName Enter the Service Name (second key part) of a Connect MQ rule ( Rule-Connect-MQ rule type). The system uses the class of the step page as the first key part of the rule.
RunInParallel Select if this connector is intended to run in parallel as a child requestor of the current requestor. If selected, use the Connect-Wait method later in the current or a follow-on activity to access results from the connector.

Results

The Connect-MQ method works as follows:

  1. Using rule resolution, locates the Connect MQ rule identified by the ServiceName parameter and the class of the step page or primary page.
  2. Uses request information in the Connect MQ rule to assemble an MQ request message.
  3. If the step page does not exist, creates a new page, of the class identified in the Pages & Classes tab.
  4. Checks whether simulation is in force for this rule. If so, calls the simulation stub activity.
  5. If simulation is not in force, sends the MQ message, in a separate thread if the RunInParallel box is selected. (This temporary requestor has the same access group and clipboard as the original.) If the limit of parallel requestors is then eventually reached, the parent requestor will fail as well. By default, the limit is 10 requestors in parallel; you can establish a higher or lower value in the prconfig.xml file or dynamic system settings using the services/maxRequestorChildren setting.
  6. Processes the MQ response message if any when it is received.

Checking the method status

This method updates the pxMethodStatus property. See How to test method results using a transition.